Sailor 6215 VHF DSC Installationshandbuch PDF herunterladen (Seite 65)

Chapter 3: Installation

Installing the VHF radio 55

3333

Installation

1. Find a suitable location for the VHF radio. Check that the space is deep

enough to accommodate the VHF radio and an additional min. 120 mm

space for cable entry.

2. Keep free distance to allow free air circulation around the VHF radio and to

allow sufficient space for access to cables, see the drawing on this page.

3. Cut out the hole for the VHF radio where you want to mount it. Use the

cutting template in the installation guide.

4. Mount the 4 square nuts M4 in the cabinet, ensure that they are placed

correct so it's possible to screw in the M4x45 screws.

5. Ensure that the flush mount gasket is placed correct on the VHF radio.

6. Before mounting the VHF radio be aware that the surface is plane and

rigid. If the surface is not plane and/or rigid (stiff) remove the gasket and

seal with silicone sealant between the VHF radio and the surface.

7. Slide the VHF radio in the cut-out. Place the flush mount bracket and fasten

it with the 4 screws M4x45. Make sure the torque does not exceed 1Nm

when fastening the screws.

Note

Only use screws supplied with the kit for flush mounting.

99-130248

Gasket

Flush Mount Bracket (2 pcs.)

Screw M4x45 TORX 20 (4 pcs.)

Connect to LOUD HAILER

(RED isolation on inner connector)

Connect to EXT. SPEAKER

(WHITE isolation on inner connector)

Connect to POWER +

(RED wire)

Connect to POWER -

(BLUE wire)

Square Nut M4x7x2.2 (4 pcs.)

Max wall thickness 26mm

Note

Firmly tie back and secure any wires not used to avoid the possibility

for mutual shorting or shorting to ground.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 101 102

Keine Kommentare

Sailor 6215 VHF DSC Installationshandbuch Seite 65